Description
Practical value and everyday use
WaveEater Power Valve Clip and Couplers Kit – for 1200cc & 1300cc Yamaha WaveRunners is listed in Valve Parts. For a practical buying decision, start with this source-backed point: Easy installation, remove only the inspection covers, 10mm wrench is all that is needed.
The source also records: Product identity: WaveEater Power Valve Clip and Couplers Kit – for 1200cc & 1300cc Yamaha WaveRunners. Use this additional stated detail to judge day-to-day usefulness and package value: Solves Power Valve problems on 1999-2005 1200cc Yamaha WaveRunners. The original Power Valve upgrade kit. A must have for all Yamaha pwc waverunner and sport boats with the YPVS system. Solves all problems associated with the Yamaha power valves used on 1200 and 1300cc engine. Look at our other listing for 800cc engines.
Value-focused decision
Compare those stated features and included items with the current on-page offer and the exact quantity needed. No performance claim is added beyond the source product record.
Complete source-backed product details
Solves Power Valve problems on 1999-2005 1200cc Yamaha WaveRunners. The original Power Valve upgrade kit. A must have for all Yamaha pwc waverunner and sport boats with the YPVS system. Solves all problems associated with the Yamaha power valves used on 1200 and 1300cc engine. Look at our other listing for 800cc engines
Source product highlights
- Solves Power Valve problems on 1200cc & 1300cc Yamaha WaveRunners
- Keeps power valve pin from sliding out of place
- Easy installation, remove only the inspection covers, 10mm wrench is all that is needed
- Can also be used For all XLT1200, GPR1200 and XR1800 sport boats
Lynn Robertson –
Fit as promised. However the instructions for the couplers was wrong. Went to their website where the instructions were right. Just be carefull when installing the clips that the cables don’t come out of the wheel.
Sean N –
Fit fine works grwat
Drew –
Clips fit great, these are the original proven design, not the cheap clips that have to provision to keep the Allen screw from backing out. Couplers are well thought out, however they were a very tight fit on the power valve shaft on my ’02 GP1200R. There is zero play in the power valve system now. I encourage everyone to double check their cable rigging after the install in accordance with the factory manual, it takes no more than 10 minuets to verify using the 4mm hole Yamaha provided in the pulley. I also added 4 oetiker clamps on the barrels to prevent the roll pins from ever falling out.
Tristan Furgason –
Purchased these for both our XLT1200cc Waverunners. Install is super easy for both the clips and couplers. Just don’t drop anything into the hull!
Brian –
Great parts came with stickers 2x of them
Travis –
this is a must have item for your GP1300R power valve engine
SR768 –
Nothing like a little assurance that if something happens to a power valve you aren’t out a cylinder.
KELTON K SMITH –
I have three 2-stroke 155 hp Yamaha Wave Runner PWC’s that will each go 65 mph.Wave eater clips are a necessity. Your power valves can disappear into the engine without them. If your Yahama power valve PWC doesn’t have them, get them installed asap.